Bushtracker Blind End Cap
Spares support for older Bushtracker products is patchy at best. Reproducing the blind end cap locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $6 – $16
- Estimated print time: 30–60 minutes
- Minimum order: 2
- Final pricing is confirmed by quote.
Spares support for older Bushtracker products is patchy at best. Reproducing the blind end cap locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Why these break
Roller blind end caps crack and the blind drops. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Bushtracker |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Roller blind end caps crack and the blind drops |
| Typical use case | Direct replacement for the original blind end cap on the Bushtracker. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $6 – $16 |
| Expected lifespan | 5+ years in normal use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
