Bushtracker Wardrobe Door Roller
Salt, sun and vibration are brutal on Bushtracker plastics, and the wardrobe door roller usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $12 – $28
- Estimated print time: 1–2 hours
- Minimum order: 2
- Final pricing is confirmed by quote.
Salt, sun and vibration are brutal on Bushtracker plastics, and the wardrobe door roller usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Why these break
Sliding door rollers flatten and doors jam. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Bushtracker |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Sliding door rollers flatten and doors jam |
| Typical use case | Direct replacement for the original wardrobe door roller on the Bushtracker. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $12 – $28 |
| Expected lifespan | 5+ years, even on moving parts |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
