CFMoto Chain Guard
Salt, sun and vibration are brutal on CFMoto plastics, and the chain guard usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $25 – $60
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
Salt, sun and vibration are brutal on CFMoto plastics, and the chain guard usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Why these break
Chain guard cracks at the mounting holes. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PETG-CF. Carbon-fibre PETG is noticeably stiffer than the stock plastic, so the part holds its shape under clamping force instead of slowly creeping loose.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | CFMoto |
|---|---|
| Vehicle / equipment type | Motorcycle |
| Common failure mode | Chain guard cracks at the mounting holes |
| Typical use case | Direct replacement for the original chain guard on the CFMoto. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG-CF |
| Alternative materials | ASA |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–4 hours |
| Estimated cost range | $25 – $60 |
| Expected lifespan | 5+ years |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
