CFMoto Tool Tray
Spares support for older CFMoto products is patchy at best. Reproducing the tool tray locally is often quicker and cheaper than the hunt for old stock. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $40
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
Spares support for older CFMoto products is patchy at best. Reproducing the tool tray locally is often quicker and cheaper than the hunt for old stock. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Underseat tool trays crack at their tabs. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | CFMoto |
|---|---|
| Vehicle / equipment type | Motorcycle |
| Common failure mode | Underseat tool trays crack at their tabs |
| Typical use case | Direct replacement for the original tool tray on the CFMoto. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–4 hours |
| Estimated cost range | $18 – $40 |
| Expected lifespan | 4–6 years in typical service |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
