Coromal Cupboard Hinge
Coromal made solid gear, but the small plastics are always the first to go — and the cupboard hinge is a regular on our bench. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Coromal made solid gear, but the small plastics are always the first to go — and the cupboard hinge is a regular on our bench. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Original hinges go brittle and snap at the knuckle. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Coromal |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Original hinges go brittle and snap at the knuckle |
| Typical use case | Direct replacement for the original cupboard hinge on the Coromal. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $24 |
| Expected lifespan | 4–6 years of regular use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
