Daihatsu Charade Window Switch Surround
The Daihatsu Charade is a vehicle worth keeping right, and a broken window switch surround shouldn't be the thing that lets it down. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $40
- Estimated print time: 2–3 hours
- Final pricing is confirmed by quote.
The Daihatsu Charade is a vehicle worth keeping right, and a broken window switch surround shouldn't be the thing that lets it down. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Surround tabs crack when the switch panel is levered out. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Daihatsu |
|---|---|
| Model | Charade |
| Year range | 1980–2004 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Surround tabs crack when the switch panel is levered out |
| Typical use case | Direct replacement for the original window switch surround on the Daihatsu Charade. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–3 hours |
| Estimated cost range | $18 – $40 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
