Electrolux Dishwasher Basket Wheel Clip
We keep getting asked about this one — the dishwasher basket wheel clip is one of those Electrolux parts that fails long before the rest of the unit is done. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $5 – $14
- Estimated print time: 20–40 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
We keep getting asked about this one — the dishwasher basket wheel clip is one of those Electrolux parts that fails long before the rest of the unit is done. With your sample on the bench this is a realistic reproduction job.
Why these break
Wheel axle clips snap and the basket derails. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Electrolux |
|---|---|
| Vehicle / equipment type | Household appliance |
| Common failure mode | Wheel axle clips snap and the basket derails |
| Typical use case | Direct replacement for the original dishwasher basket wheel clip on the Electrolux. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 20–40 minutes |
| Estimated cost range | $5 – $14 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | Depends |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
