Ford Ranger PJ–PK Door Trim Clip
This is the kind of door trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Ford Ranger PJ–PK these days. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $12
- Estimated print time: 15–30 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
This is the kind of door trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Ford Ranger PJ–PK these days. We've made this style of part before and can usually print yours without drama.
Why these break
Clips snap when the door card is removed. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Ford |
|---|---|
| Model | Ranger PJ–PK |
| Year range | 2006–2011 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Clips snap when the door card is removed |
| Typical use case | Direct replacement for the original door trim clip on the Ford Ranger PJ–PK. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $12 |
| Expected lifespan | 4–6 years in typical service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
