Ford Ranger PX Boot Trim Clip
This is the kind of boot trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Ford Ranger PX these days. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 6
- Final pricing is confirmed by quote.
This is the kind of boot trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Ford Ranger PX these days. We've made this style of part before and can usually print yours without drama.
Why these break
Boot and tailgate trim clips crack with age. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Ford |
|---|---|
| Model | Ranger PX |
| Year range | 2011–2022 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Boot and tailgate trim clips crack with age |
| Typical use case | Direct replacement for the original boot trim clip on the Ford Ranger PX. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 3–5 years of Australian UV |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
