Full Boar Side Handle Clamp
Salt, sun and vibration are brutal on Full Boar plastics, and the side handle clamp usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Salt, sun and vibration are brutal on Full Boar plastics, and the side handle clamp usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Why these break
Side handle clamps crack at the collar. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Full Boar |
|---|---|
| Vehicle / equipment type | Power tool |
| Common failure mode | Side handle clamps crack at the collar |
| Typical use case | Direct replacement for the original side handle clamp on the Full Boar. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years in hard service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
