Gas Bottle Holder Wing Knob
Chunky wing knobs for gas bottle clamps — printed oversize so cold fingers can actually undo them.
Chunky wing knobs for gas bottle clamps — printed oversize so cold fingers can actually undo them.
Common failure: Wing knobs on the bottle clamp seize and snap.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we’ll let you know what’s realistic before any work starts.
Part details
| Vehicle / equipment type | A-frame gas bottle holders |
|---|---|
| Common failure mode | Wing knobs on the bottle clamp seize and snap |
| Typical use case | Replacement part for a-frame gas bottle holders. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG-CF |
| Alternative materials | ASA |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $22 |
| Expected lifespan | 3–5 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
