Goldstream Cupboard Hinge
Goldstream made solid gear, but the small plastics are always the first to go — and the cupboard hinge is a regular on our bench. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $24
- Estimated print time: 1–2 hours
- Minimum order: 2
- Final pricing is confirmed by quote.
Goldstream made solid gear, but the small plastics are always the first to go — and the cupboard hinge is a regular on our bench. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Original hinges go brittle and snap at the knuckle. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Goldstream |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Original hinges go brittle and snap at the knuckle |
| Typical use case | Direct replacement for the original cupboard hinge on the Goldstream. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $24 |
| Expected lifespan | 5+ years in service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
