Greenfield Mower Wheel Hub Cap
Greenfield made solid gear, but the small plastics are always the first to go — and the mower wheel hub cap is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $8 – $18
- Estimated print time: 30–60 minutes
- Minimum order: 2
- Final pricing is confirmed by quote.
Greenfield made solid gear, but the small plastics are always the first to go — and the mower wheel hub cap is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Why these break
Hub caps crack and wheels loosen on the axle. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Greenfield |
|---|---|
| Vehicle / equipment type | Lawn mower |
| Common failure mode | Hub caps crack and wheels loosen on the axle |
| Typical use case | Direct replacement for the original mower wheel hub cap on the Greenfield. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $18 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
