Haines Hunter Seat Swivel Bush
Spares support for older Haines Hunter products is patchy at best. Reproducing the seat swivel bush locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $25
- Estimated print time: 1–2 hours
- Minimum order: 2
- Final pricing is confirmed by quote.
Spares support for older Haines Hunter products is patchy at best. Reproducing the seat swivel bush locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Why these break
Swivel bushes wear and seats rock. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Haines Hunter |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Swivel bushes wear and seats rock |
| Typical use case | Direct replacement for the original seat swivel bush on the Haines Hunter. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PA-CF |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $25 |
| Expected lifespan | 5+ years, even on moving parts |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
