Harley-Davidson Tool Tray
Salt, sun and vibration are brutal on Harley-Davidson plastics, and the tool tray usually gives up first. A tougher printed replacement breaks that cycle. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $40
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
Salt, sun and vibration are brutal on Harley-Davidson plastics, and the tool tray usually gives up first. A tougher printed replacement breaks that cycle. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Underseat tool trays crack at their tabs. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Harley-Davidson |
|---|---|
| Vehicle / equipment type | Motorcycle |
| Common failure mode | Underseat tool trays crack at their tabs |
| Typical use case | Direct replacement for the original tool tray on the Harley-Davidson. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–4 hours |
| Estimated cost range | $18 – $40 |
| Expected lifespan | 3–5 years in normal use |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
