Holden Captiva Headlight Tab Repair
The Holden Captiva is a vehicle worth keeping right, and a broken headlight tab repair shouldn't be the thing that lets it down. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $40 – $90
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
The Holden Captiva is a vehicle worth keeping right, and a broken headlight tab repair shouldn't be the thing that lets it down. With your sample on the bench this is a realistic reproduction job.
Why these break
Headlight mounting tabs snap in minor bumps. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
Complex geometry means we treat this as a small engineering project — scan, model, test print, refine. We'll quote before any work starts so there are no surprises.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Captiva |
| Year range | 2006–2018 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Headlight mounting tabs snap in minor bumps |
| Typical use case | Direct replacement for the original headlight tab repair on the Holden Captiva. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Hard |
| Estimated print time | 2–4 hours |
| Estimated cost range | $40 – $90 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
