Holden Commodore VE Mudflap Clip
We see a steady stream of Holden Commodore VE owners chasing this exact part — the mudflap clip is a known weak point once the plastic has a decade of heat cycles in it. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $3 – $8
- Estimated print time: 10–20 minutes
- Minimum order: 8
- Final pricing is confirmed by quote.
We see a steady stream of Holden Commodore VE owners chasing this exact part — the mudflap clip is a known weak point once the plastic has a decade of heat cycles in it. With your sample on the bench this is a realistic reproduction job.
Why these break
Mudflap clips shear off on kerbs and rough tracks. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Commodore VE |
| Year range | 2006–2013 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Mudflap clips shear off on kerbs and rough tracks |
| Typical use case | Direct replacement for the original mudflap clip on the Holden Commodore VE. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 10–20 minutes |
| Estimated cost range | $3 – $8 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
