Holden Commodore VF Boot Trim Clip
This is the kind of boot trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Holden Commodore VF these days. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 6
- Final pricing is confirmed by quote.
This is the kind of boot trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Holden Commodore VF these days. With your sample on the bench this is a realistic reproduction job.
Why these break
Boot and tailgate trim clips crack with age. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Commodore VF |
| Year range | 2013–2017 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Boot and tailgate trim clips crack with age |
| Typical use case | Direct replacement for the original boot trim clip on the Holden Commodore VF. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
