Holden Statesman WH–WL Boot Latch Cover
The Holden Statesman WH–WL is a vehicle worth keeping right, and a broken boot latch cover shouldn't be the thing that lets it down. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $24
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
The Holden Statesman WH–WL is a vehicle worth keeping right, and a broken boot latch cover shouldn't be the thing that lets it down. With your sample on the bench this is a realistic reproduction job.
Why these break
Latch trim cover cracks around its clips. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Statesman WH–WL |
| Year range | 1999–2006 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Latch trim cover cracks around its clips |
| Typical use case | Direct replacement for the original boot latch cover on the Holden Statesman WH–WL. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $24 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
