Husqvarna Mower Grass Catcher Clip
A broken mower grass catcher clip shouldn't sideline otherwise good Husqvarna equipment, and with a decent sample to work from it usually doesn't have to. With your sample on the bench this is a realistic reproduction job.
A broken mower grass catcher clip shouldn't sideline otherwise good Husqvarna equipment, and with a decent sample to work from it usually doesn't have to. With your sample on the bench this is a realistic reproduction job.
Why these break
Catcher clips snap and the catcher falls off mid-mow. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Husqvarna |
|---|---|
| Vehicle / equipment type | Lawn mower |
| Common failure mode | Catcher clips snap and the catcher falls off mid-mow |
| Typical use case | Direct replacement for the original mower grass catcher clip on the Husqvarna. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $20 |
| Expected lifespan | 3–5 years of Australian UV |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
