Hyundai Excel Door Sill Scuff Trim Clip
Wreckers are drying up for the Hyundai Excel, and when they do have one, its door sill scuff trim clip is usually just as brittle as yours. Printing a fresh one solves that. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 6
- Final pricing is confirmed by quote.
Wreckers are drying up for the Hyundai Excel, and when they do have one, its door sill scuff trim clip is usually just as brittle as yours. Printing a fresh one solves that. We've made this style of part before and can usually print yours without drama.
Why these break
Sill trim clips crack underfoot over the years. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Hyundai |
|---|---|
| Model | Excel |
| Year range | 1986–2000 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Sill trim clips crack underfoot over the years |
| Typical use case | Direct replacement for the original door sill scuff trim clip on the Hyundai Excel. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
