Hyundai i30 Wheel Arch Liner Clip
A wheel arch liner clip for the Hyundai i30 is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $3 – $8
- Estimated print time: 10–20 minutes
- Minimum order: 10
- Final pricing is confirmed by quote.
A wheel arch liner clip for the Hyundai i30 is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. We've made this style of part before and can usually print yours without drama.
Why these break
Liner clips break during tyre changes and scrapes. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Hyundai |
|---|---|
| Model | i30 |
| Year range | 2007–2021 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Liner clips break during tyre changes and scrapes |
| Typical use case | Direct replacement for the original wheel arch liner clip on the Hyundai i30. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 10–20 minutes |
| Estimated cost range | $3 – $8 |
| Expected lifespan | 5+ years, even on moving parts |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
