Jeep Wrangler Wheel Arch Liner Clip
This is the kind of wheel arch liner clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Jeep Wrangler these days. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $3 – $8
- Estimated print time: 10–20 minutes
- Minimum order: 10
- Final pricing is confirmed by quote.
This is the kind of wheel arch liner clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Jeep Wrangler these days. With your sample on the bench this is a realistic reproduction job.
Why these break
Liner clips break during tyre changes and scrapes. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Jeep |
|---|---|
| Model | Wrangler |
| Year range | 1996–2018 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Liner clips break during tyre changes and scrapes |
| Typical use case | Direct replacement for the original wheel arch liner clip on the Jeep Wrangler. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 10–20 minutes |
| Estimated cost range | $3 – $8 |
| Expected lifespan | 5+ years in service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
