Kelvinator Washing Machine Soap Drawer Lug
If the washing machine soap drawer lug on your Kelvinator has cracked or crumbled, it's a part we can usually sort without chasing discontinued spares. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $20 – $45
- Estimated print time: 1–3 hours
- Final pricing is confirmed by quote.
If the washing machine soap drawer lug on your Kelvinator has cracked or crumbled, it's a part we can usually sort without chasing discontinued spares. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Drawer guide lugs snap so the drawer jams or falls out. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Kelvinator |
|---|---|
| Vehicle / equipment type | Household appliance |
| Common failure mode | Drawer guide lugs snap so the drawer jams or falls out |
| Typical use case | Direct replacement for the original washing machine soap drawer lug on the Kelvinator. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–3 hours |
| Estimated cost range | $20 – $45 |
| Expected lifespan | 4–6 years in typical service |
| Outdoor suitable | No |
| Heat resistant | Depends |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
