Lockwood Window Winder Handle
Spares support for older Lockwood products is patchy at best. Reproducing the window winder handle locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Spares support for older Lockwood products is patchy at best. Reproducing the window winder handle locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Why these break
Winder handles snap at the spindle square. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Lockwood |
|---|---|
| Vehicle / equipment type | Window / door hardware |
| Common failure mode | Winder handles snap at the spindle square |
| Typical use case | Direct replacement for the original window winder handle on the Lockwood. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $14 – $32 |
| Expected lifespan | 4–6 years of regular use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
