Lotus Caravans Window Stay Arm
Salt, sun and vibration are brutal on Lotus Caravans plastics, and the window stay arm usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $14 – $32
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
Salt, sun and vibration are brutal on Lotus Caravans plastics, and the window stay arm usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Why these break
Stay arms snap at the pivot hole. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PETG-CF. Carbon-fibre PETG is noticeably stiffer than the stock plastic, so the part holds its shape under clamping force instead of slowly creeping loose.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Lotus Caravans |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Stay arms snap at the pivot hole |
| Typical use case | Direct replacement for the original window stay arm on the Lotus Caravans. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG-CF |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $14 – $32 |
| Expected lifespan | 5+ years in normal use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
