Mazda BT-50 Washer Jet Clip
We see a steady stream of Mazda BT-50 owners chasing this exact part — the washer jet clip is a known weak point once the plastic has a decade of heat cycles in it. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $6 – $15
- Estimated print time: 30–60 minutes
- Minimum order: 2
- Final pricing is confirmed by quote.
We see a steady stream of Mazda BT-50 owners chasing this exact part — the washer jet clip is a known weak point once the plastic has a decade of heat cycles in it. With your sample on the bench this is a realistic reproduction job.
Why these break
Washer jet clips crack from engine bay heat and UV. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Mazda |
|---|---|
| Model | BT-50 |
| Year range | 2006–2020 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Washer jet clips crack from engine bay heat and UV |
| Typical use case | Direct replacement for the original washer jet clip on the Mazda BT-50. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $6 – $15 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
