Mercedes-Benz Sprinter Washer Jet Clip
Wreckers are drying up for the Mercedes-Benz Sprinter, and when they do have one, its washer jet clip is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $6 – $15
- Estimated print time: 30–60 minutes
- Minimum order: 2
- Final pricing is confirmed by quote.
Wreckers are drying up for the Mercedes-Benz Sprinter, and when they do have one, its washer jet clip is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Why these break
Washer jet clips crack from engine bay heat and UV. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Mercedes-Benz |
|---|---|
| Model | Sprinter |
| Year range | 1995–2020 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Washer jet clips crack from engine bay heat and UV |
| Typical use case | Direct replacement for the original washer jet clip on the Mercedes-Benz Sprinter. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $6 – $15 |
| Expected lifespan | 3–5 years of Australian UV |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
