Mitsubishi Challenger Washer Jet Clip
Wreckers are drying up for the Mitsubishi Challenger, and when they do have one, its washer jet clip is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $6 – $15
- Estimated print time: 30–60 minutes
- Minimum order: 2
- Final pricing is confirmed by quote.
Wreckers are drying up for the Mitsubishi Challenger, and when they do have one, its washer jet clip is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Why these break
Washer jet clips crack from engine bay heat and UV. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Mitsubishi |
|---|---|
| Model | Challenger |
| Year range | 1998–2015 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Washer jet clips crack from engine bay heat and UV |
| Typical use case | Direct replacement for the original washer jet clip on the Mitsubishi Challenger. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $6 – $15 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
