Mitsubishi Delica Cup Holder Insert
The Mitsubishi Delica is a vehicle worth keeping right, and a broken cup holder insert shouldn't be the thing that lets it down. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $42
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
The Mitsubishi Delica is a vehicle worth keeping right, and a broken cup holder insert shouldn't be the thing that lets it down. With your sample on the bench this is a realistic reproduction job.
Why these break
Divider flaps and spring arms snap off. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Mitsubishi |
|---|---|
| Model | Delica |
| Year range | 1994–2007 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Divider flaps and spring arms snap off |
| Typical use case | Direct replacement for the original cup holder insert on the Mitsubishi Delica. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–4 hours |
| Estimated cost range | $18 – $42 |
| Expected lifespan | 3–5 years in normal use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
