Mitsubishi Delica Seat Trim Clip
This is the kind of seat trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Mitsubishi Delica these days. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
This is the kind of seat trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Mitsubishi Delica these days. With your sample on the bench this is a realistic reproduction job.
Why these break
Seat plastics clips snap during repairs and removals. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Mitsubishi |
|---|---|
| Model | Delica |
| Year range | 1994–2007 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Seat plastics clips snap during repairs and removals |
| Typical use case | Direct replacement for the original seat trim clip on the Mitsubishi Delica. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
