Mitsubishi Triton Cup Holder Insert
A cup holder insert for the Mitsubishi Triton is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $42
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
A cup holder insert for the Mitsubishi Triton is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. With your sample on the bench this is a realistic reproduction job.
Why these break
Divider flaps and spring arms snap off. Vibration fatigue does the damage: thousands of kilometres of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Mitsubishi |
|---|---|
| Model | Triton |
| Year range | 1996–2019 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Divider flaps and spring arms snap off |
| Typical use case | Direct replacement for the original cup holder insert on the Mitsubishi Triton. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–4 hours |
| Estimated cost range | $18 – $42 |
| Expected lifespan | 4–6 years in typical service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
