Omega Washer Lid Hinge
Spares support for older Omega products is patchy at best. Reproducing the washer lid hinge locally is often quicker and cheaper than the hunt for old stock. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Spares support for older Omega products is patchy at best. Reproducing the washer lid hinge locally is often quicker and cheaper than the hunt for old stock. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Top loader lid hinges snap at the pin. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Omega |
|---|---|
| Vehicle / equipment type | Household appliance |
| Common failure mode | Top loader lid hinges snap at the pin |
| Typical use case | Direct replacement for the original washer lid hinge on the Omega. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years of regular use |
| Outdoor suitable | No |
| Heat resistant | Depends |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
