Pop-Up Sprinkler Cap
Sprinkler caps involve threads and O-ring seats, so results vary by model. We're trialling these — worth an ask before you replace a whole run.
Sprinkler caps involve threads and O-ring seats, so results vary by model. We're trialling these — worth an ask before you replace a whole run.
Common failure: Caps crack after being clipped by the mower.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we’ll let you know what’s realistic before any work starts.
Part details
| Vehicle / equipment type | Common retic systems |
|---|---|
| Common failure mode | Caps crack after being clipped by the mower |
| Typical use case | Replacement part for common retic systems. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Experimental |
| Estimated print time | 1–2 hours |
| Estimated cost range | $8 – $20 |
| Expected lifespan | 1–3 years |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
