Primus Swag Pole Joiner
If the swag pole joiner on your Primus has cracked or crumbled, it's a part we can usually sort without chasing discontinued spares. We've made this style of part before and can usually print yours without drama.
If the swag pole joiner on your Primus has cracked or crumbled, it's a part we can usually sort without chasing discontinued spares. We've made this style of part before and can usually print yours without drama.
Why these break
Pole joiners crack at the spigot. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — years on, there's no margin left in it.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Primus |
|---|---|
| Vehicle / equipment type | Camping gear |
| Common failure mode | Pole joiners crack at the spigot |
| Typical use case | Replacement part for camping gear. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $24 |
| Expected lifespan | 4–6 years in hard service |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
