Quintrex Transducer Bracket
Spares support for older Quintrex products is patchy at best. Reproducing the transducer bracket locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Spares support for older Quintrex products is patchy at best. Reproducing the transducer bracket locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Why these break
Transducer brackets snap at the transom mount. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Quintrex |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Transducer brackets snap at the transom mount |
| Typical use case | Direct replacement for the original transducer bracket on the Quintrex. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | ASA |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–3 hours |
| Estimated cost range | $18 – $42 |
| Expected lifespan | 5+ years under load |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
