Royal Flair Cupboard Catch
Royal Flair made solid gear, but the small plastics are always the first to go — and the cupboard catch is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $8 – $20
- Estimated print time: 30–60 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
Royal Flair made solid gear, but the small plastics are always the first to go — and the cupboard catch is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Why these break
Spring tab loses tension so cupboards fly open in transit. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Royal Flair |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Spring tab loses tension so cupboards fly open in transit |
| Typical use case | Direct replacement for the original cupboard catch on the Royal Flair. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $20 |
| Expected lifespan | 4–6 years in typical service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
