Sea Jay Rod Holder Cap
A broken rod holder cap shouldn't sideline otherwise good Sea Jay equipment, and with a decent sample to work from it usually doesn't have to. With your sample on the bench this is a realistic reproduction job.
A broken rod holder cap shouldn't sideline otherwise good Sea Jay equipment, and with a decent sample to work from it usually doesn't have to. With your sample on the bench this is a realistic reproduction job.
Why these break
Rod holder caps crack and let water into the gunwale. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Sea Jay |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Rod holder caps crack and let water into the gunwale |
| Typical use case | Direct replacement for the original rod holder cap on the Sea Jay. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | TPU |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $20 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
