Sega Console Feet
We keep getting asked about this one — the console feet is one of those Sega parts that fails long before the rest of the unit is done. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
We keep getting asked about this one — the console feet is one of those Sega parts that fails long before the rest of the unit is done. We've made this style of part before and can usually print yours without drama.
Why these break
Rubber feet perish and consoles slide and scratch. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — years on, there's no margin left in it.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in TPU. TPU is flexible and grippy, so it absorbs the impacts and vibration that crack rigid plastics, and it is kind to the surfaces it touches.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Sega |
|---|---|
| Vehicle / equipment type | Retro console |
| Common failure mode | Rubber feet perish and consoles slide and scratch |
| Typical use case | Replacement part for retro console. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | TPU |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 3–5 years in normal use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
