ToolPRO Case Latch
ToolPRO made solid gear, but the small plastics are always the first to go — and the case latch is a regular on our bench. We've made this style of part before and can usually print yours without drama.
ToolPRO made solid gear, but the small plastics are always the first to go — and the case latch is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Why these break
Case latches crack in the cold or under a boot. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | ToolPRO |
|---|---|
| Vehicle / equipment type | Power tool |
| Common failure mode | Case latches crack in the cold or under a boot |
| Typical use case | Direct replacement for the original case latch on the ToolPRO. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $12 – $28 |
| Expected lifespan | 4–6 years in hard service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
