Toyota 86 Window Switch Surround
This is the kind of window switch surround that dealers only sell as part of a whole assembly — if they can supply it at all for a Toyota 86 these days. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $40
- Estimated print time: 2–3 hours
- Final pricing is confirmed by quote.
This is the kind of window switch surround that dealers only sell as part of a whole assembly — if they can supply it at all for a Toyota 86 these days. With your sample on the bench this is a realistic reproduction job.
Why these break
Surround tabs crack when the switch panel is levered out. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Toyota |
|---|---|
| Model | 86 |
| Year range | 2012–2021 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Surround tabs crack when the switch panel is levered out |
| Typical use case | Direct replacement for the original window switch surround on the Toyota 86. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–3 hours |
| Estimated cost range | $18 – $40 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
