Toyota LandCruiser 100 Door Sill Scuff Trim Clip
We see a steady stream of Toyota LandCruiser 100 owners chasing this exact part — the door sill scuff trim clip is a known weak point once the plastic has a decade of heat cycles in it. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 6
- Final pricing is confirmed by quote.
We see a steady stream of Toyota LandCruiser 100 owners chasing this exact part — the door sill scuff trim clip is a known weak point once the plastic has a decade of heat cycles in it. We've made this style of part before and can usually print yours without drama.
Why these break
Sill trim clips crack underfoot over the years. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Toyota |
|---|---|
| Model | LandCruiser 100 |
| Year range | 1998–2007 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Sill trim clips crack underfoot over the years |
| Typical use case | Direct replacement for the original door sill scuff trim clip on the Toyota LandCruiser 100. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
