Toyota LandCruiser 200 Seat Trim Clip
A seat trim clip for the Toyota LandCruiser 200 is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
A seat trim clip for the Toyota LandCruiser 200 is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. With your sample on the bench this is a realistic reproduction job.
Why these break
Seat plastics clips snap during repairs and removals. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Toyota |
|---|---|
| Model | LandCruiser 200 |
| Year range | 2007–2021 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Seat plastics clips snap during repairs and removals |
| Typical use case | Direct replacement for the original seat trim clip on the Toyota LandCruiser 200. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
