Toyota Prado Interior Mirror Trim Cap
This is the kind of interior mirror trim cap that dealers only sell as part of a whole assembly — if they can supply it at all for a Toyota Prado these days. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $22
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
This is the kind of interior mirror trim cap that dealers only sell as part of a whole assembly — if they can supply it at all for a Toyota Prado these days. With your sample on the bench this is a realistic reproduction job.
Why these break
Mirror stem trim cap cracks or goes missing. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Toyota |
|---|---|
| Model | Prado |
| Year range | 1996–2023 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Mirror stem trim cap cracks or goes missing |
| Typical use case | Direct replacement for the original interior mirror trim cap on the Toyota Prado. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $22 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | Depends |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
