Coromal Table Leg Foot Cap
Coromal made solid gear, but the small plastics are always the first to go — and the table leg foot cap is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Coromal made solid gear, but the small plastics are always the first to go — and the table leg foot cap is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Why these break
Foot caps split and scratch the floor. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in TPU. TPU is flexible and grippy, so it absorbs the impacts and vibration that crack rigid plastics, and it is kind to the surfaces it touches.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Coromal |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Foot caps split and scratch the floor |
| Typical use case | Direct replacement for the original table leg foot cap on the Coromal. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | TPU |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 20–40 minutes |
| Estimated cost range | $5 – $12 |
| Expected lifespan | 3–5 years in normal use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
