Harley-Davidson Side Cover Grommet Mount
Spares support for older Harley-Davidson products is patchy at best. Reproducing the side cover grommet mount locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $15 – $35
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
Spares support for older Harley-Davidson products is patchy at best. Reproducing the side cover grommet mount locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Why these break
Side cover pegs snap off leaving the cover loose. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Harley-Davidson |
|---|---|
| Vehicle / equipment type | Motorcycle |
| Common failure mode | Side cover pegs snap off leaving the cover loose |
| Typical use case | Direct replacement for the original side cover grommet mount on the Harley-Davidson. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
