Evinrude Nav Light Base
Spares support for older Evinrude products is patchy at best. Reproducing the nav light base locally is often quicker and cheaper than the hunt for old stock. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Spares support for older Evinrude products is patchy at best. Reproducing the nav light base locally is often quicker and cheaper than the hunt for old stock. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Light bases crack and the light works loose. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Evinrude |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Light bases crack and the light works loose |
| Typical use case | Direct replacement for the original nav light base on the Evinrude. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
