Full Boar Battery Mount Clip
Salt, sun and vibration are brutal on Full Boar plastics, and the battery mount clip usually gives up first. A tougher printed replacement breaks that cycle. We've made this style of part before and can usually print yours without drama.
Salt, sun and vibration are brutal on Full Boar plastics, and the battery mount clip usually gives up first. A tougher printed replacement breaks that cycle. We've made this style of part before and can usually print yours without drama.
Why these break
Wall-mount and holder clips crack at the rail. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in PETG-CF. Carbon-fibre PETG is noticeably stiffer than the stock plastic, so the part holds its shape under clamping force instead of slowly creeping loose.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Full Boar |
|---|---|
| Vehicle / equipment type | Power tool |
| Common failure mode | Wall-mount and holder clips crack at the rail |
| Typical use case | Direct replacement for the original battery mount clip on the Full Boar. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG-CF |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $25 |
| Expected lifespan | 4–6 years under clamping load |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
