Hoover Fridge Shelf End Cap

Salt, sun and vibration are brutal on Hoover plastics, and the fridge shelf end cap usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.

Why these break

Shelf rail end caps crack and shelves slide out. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.

How we reproduce them

Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.

We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.

Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.