Bostitch Side Handle Clamp
Spares support for older Bostitch products is patchy at best. Reproducing the side handle clamp locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Spares support for older Bostitch products is patchy at best. Reproducing the side handle clamp locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Why these break
Side handle clamps crack at the collar. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Bostitch |
|---|---|
| Vehicle / equipment type | Power tool |
| Common failure mode | Side handle clamps crack at the collar |
| Typical use case | Direct replacement for the original side handle clamp on the Bostitch. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 5+ years under load |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
